Allow at least 11 inches of depth behind the panel to accommodate the unit, the rear connector, and the cable service loop.
Avionics installation should be performed or supervised by a certified A&P mechanic or an FAA-approved radio shop. Improper wiring can lead to electrical fires or loss of critical navigation equipment. narco escort ii installation manual full
: Once installed and configured, test to ensure everything is working as expected. Allow at least 11 inches of depth behind
The Escort II uses a multi-pin connector (P301) for power, audio, and antenna interfacing. For a standard 14V installation, a jumper is required between pins 8 and 10. Wire Size/Color 14/28V Power Input 18 AWG (Red) 2 14/28V Power Input 18 AWG (Red) 3 Airframe Ground 18 AWG (Black) 4 Airframe Ground 18 AWG (Black) 5 Low Level Audio 20 AWG (Green) 6 Headphones Audio (50 mW) 20 AWG (Blue) 9 Transmitter Key 20 AWG (White) 10 Switched A+ (Output) 18 AWG (White/Red) 11 Mike Audio 20 AWG (Brown) 12 Intercom Key 20 AWG (Yellow) 13 Mike/Phones Ground 20 AWG (Black) Data sourced from the Narco Escort II Pinout Diagram . Antenna Installation : Once installed and configured, test to ensure
: Pay close attention to each screen of the installation wizard.
Using a ramp tester (IFR-6000 or T-40D), you must verify: