Kt 70 Installation Manual [new]

This article is for informational purposes. Electrical systems can be dangerous. The author assumes no responsibility for damage or injury resulting from improper installation. Always follow local regulations for e-bike modifications.

Note: treat manufacturer-supplied documentation, nameplate ratings, and local electrical/building codes as the authoritative sources. Use this guide to supplement and clarify common steps and pitfalls. Kt 70 Installation Manual

Standby (SBY), Test (TST), Ground (GND), ON, and Altitude (ALT). 2. Installation Guidelines This article is for informational purposes

| Parameter | Description | Typical Setting | |-----------|-------------|------------------| | | Sensor type | K (for K-thermocouple), Pt100 | | Unit | Temperature unit | °C or °F | | OPL | Output power limit | 100% (unless limiting heater) | | AL1 | Alarm 1 setpoint | e.g., 50°C above SP | | HY1 | Alarm hysteresis | 2°C | Always follow local regulations for e-bike modifications

| Code | Cause | Solution | |------|-------|----------| | | Sensor open or reversed | Check continuity; reverse TC wires (no polarity on RTD) | | HHH | Input > range | Sensor type mismatch or short circuit | | LLL | Input < range | Sensor disconnected or below zero | | E.OP1 | Output 1 short-circuit | Check SSR or heater coil resistance |