| Error Code | Message | Solution | |------------|---------|----------| | E001 | "Exclusive key mismatch" | The hardware dongle is not detected. Reinstall drivers or apply the bypass patch (only available in v1032ex_patch). | | E047 | "NAND block 1024 timeout" | Baud rate too high. Fall back to 115200. | | E089 | "Firmware CRC fail after write" | Bad RAM timing. Add --delay 50 flag. | | E102 | "Bootloader signature rejected" | You need the -unsafe flag to skip RSA check. |
If your receiver is stuck on "ON," "Boot," or shows a red light, this tool can re-write the bootloader to revive the hardware. gxdownloaderbootv1032 exclusive
: The tool must be set to the correct COM port and Baud rate (usually 115200) to ensure the data packets align with the processor's clock. | Error Code | Message | Solution |